Basic metrological tests I: installation and operating conditions

on
Categories: Knowledge Base

Reliable weighing begins before the first sample is loaded. Installation should establish a suitable location, support, operating environment and measurement procedure for the instrument's intended use.

The first part of the series links mechanical design, ambient conditions and method to the quality of a result. An intuitive interface does not remove the need to understand how these factors influence the measurement.

Document the initial setup, let the equipment reach the required operating condition and perform the relevant adjustment and checks. During use, watch for changes in the room or process that could invalidate the original assumptions. This creates a practical basis for the more specific performance tests discussed in the later parts of the series.

Illustrations from the original technical article. Select an image to view it at full size.

Source: RADWAG technical article.

Related technical articles:
Basic metrological tests II: preparing and performing balance checks
Basic metrological tests III: minimum weight and analytical-balance checks
Basic metrological tests IV: readability and verification intervals

Views5