Basic metrological tests III: minimum weight and analytical-balance checks

on
Categories: Knowledge Base

The third part of the series discusses how small-sample work connects repeatability, accuracy, minimum weight and instrument adjustment. These concepts address different aspects of performance and should not be reduced to one specification.

A lower sample threshold depends on the measurement requirement and the balance's demonstrated behaviour. Adjustment reports and automated tests can provide useful information, but their results need to be interpreted within the laboratory procedure.

Define the required performance, assess the relevant characteristics and record what was tested. Where a pharmacopoeial or other controlled method applies, use its applicable requirements rather than assuming that a named instrument feature establishes compliance by itself.

Safety of Mass Measurement in Pharmaceutical Industry. Basic Metrological Tests (part III) – image 02

Source: RADWAG technical article.

Related technical articles:
Basic metrological tests I: installation and operating conditions
Basic metrological tests II: preparing and performing balance checks
Basic metrological tests IV: readability and verification intervals

Views4