AVK 1000.5Y Automatic Vacuum Mass Comparator equipped with pumps

Code: WL-417-0003

Compare products
Quote list
Views3

AVK1000.5Y

 
Discover an advanced metrology solution with the AVK 1000.5Y automatic vacuum mass comparator. This innovative piece of equipment is designed for precise mass comparison under vacuum conditions of 10-6 mbar, eliminating the influence of air on measurements. Equipped with state-of-the-art pumps, it ensures efficient air extraction, thereby speeding up the measurement process and increasing the accuracy of the results.

 

 

 

Vacuum Levels of up to 10-6 mbar? Not a Problem for us!

The comparator is equipped with a pumping system that consists of 2 pumps: a pre-pump and a turbomolecular pump, as well as a high-performance vacuum gauge. Pre-pumps and turbomolecular pumps work together to ensure vacuum continuity and stability in systems where different vacuum qualities are required. The pre-pump lowers the pressure to a level where the turbomolecular pump can operate effectively, allowing the desired vacuum to be achieved throughout the system.

 

 

The pre-pump

It works on the principle of mechanical suction of gases and their compression. Its main task is to reduce the pressure to a level where the turbomolecular pumps can operate effectively. These pumps are capable of producing a vacuum of 10-3  to 10-4 hPa.

The turbomolecular pump

It uses impellers rotating at very high speeds to accelerate gas molecules. These molecules are “pulled” into the pump by the action of centrifugal force. It allows much lower pressures (up to 10-10 hPa) than pre-pumps.

 

 

 

 

Convenience and Full Control over the Process

The high-performance vacuum gauges used in the device allow the vacuum values to be monitored and compared in order to determine when the valve can be opened and the gauge replaced. A specially made viewfinder allows the entire process to be monitored. During mass standards exchange, air enters directly into the main chamber of the comparator. Each time it is opened, the air must be pumped out to the correct vacuum value. The vacuum comparator requires approximately 48 hours to reach a vacuum value that ensures repeatability of measurements.

 

 

 

 

 

What Additional Capabilities Does the AVK-1000.5Y Have?

 

Automatic calibration mechanism

with the possibility of replacing the calibration mass standard with a mass standard of lesser mass to check the sensitivity of the comparator.

 

 

 

Comparison capability in a noble gas atmosphere

A key element in the design of the comparator is a specially designed vacuum chamber that allows measurements to be carried out under vacuum conditions of 10-6 mbar or in a noble gas atmosphere. This enables stable and repeatable results even under the most demanding conditions.

 

 

 

6-position mass standard magazine

It allows automatic exchange of mass standards during the measuring process.

 

 

 

Self-centring weighing pan

This is a component of the comparator which ensures that the mass standard is always in the centre of the pan, regardless of its initial position. It eliminates the problem of eccentricity.

 

 

 

Thermohygrobarometer

It exercises comprehensive control over the precision measurement environment, increasing accuracy and improving repeatability.

 

 

 

Anti-vibration table with granite top

It eliminates the effects of ambient vibration to keep measurements stable during weighing. You receive the table together with the comparator.

 

 

 

Intuitive control

The AVK 1000.5Y comparator is not only efficient, but also intuitive to use thanks to the 10’’ touchscreen display, which allows easy management of the device’s functions. In addition, security of use is ensured through a variety of authentication methods, including passwords, RFID tags*, fingerprint readers and facial recognition mechanisms.

 

 

 

 

* RFID ISO/IEC 14443 Type A, 13.56 MHz

 

 

Maximum capacity [Max]1002 g
Readability [d]0,1 µg
Weighing pan dimensionsø100 mm
Operating temperature+15 – +30 °C
Relative humidity45% – 60%
Power supply100 – 240 V AC 50/60 Hz
Communication interface2×USB-A, USB-C, RS 232 (COM3), HDMI, Ethernet, Wi-Fi, Hotspot
Display10″ graphic colour touchscreen
Adjustmentinternal / external
Standard repeatability [5% Max]0,4 µg **
Standard repeatability [Max]0,5 µg **
Linearity±2 µg
Stabilization time60 s
Operating temperature change rate±0,1 °C / 12 h
Relative humidity change rate±2% / 4 h
Weighing device dimensions965×745×1700 mm
Controling device dimensions249×170×72 mm
Magazine6
E1 Calibration Range100 g – 1 kg
E2 Calibration Range100 g – 1 kg
F1 Calibration Range100 g – 1 kg
F2 Calibration Range100 g – 1 kg
Electric compensation range-1 g – +2 g
Supplementary weights external500 g, 800 g, 900 g
Permissible repeatability0,8 µg
E0 Calibration Range100 g – 1 kg *
Object diameterscylindrical ø (22 – 95)x110; spherical ø (40 – 100) mm
Pressure range10(⁻⁶) mbar
Vacuum chamber dimensions965×745×1150 mm
Net weight (without table)250 kg
Net weight (with table)650 kg
  • Air density correction
  • ALIBI Memory
  • Ambient conditions monitoring
  • Animal weighing
  • Automatic sliding door
  • Autotest
  • BMI
  • Checkweighing
  • Density determination
  • Differential weighing
  • Dosing
  • Dry mass determination
  • Drying modes
  • Formulation
  • GLP Procedures
  • Internal battery
  • IR sensors
  • Labelling
  • Mass for titrator
  • Microwave drying
  • Moisture content analysis
  • Moveable range
  • Newton unit measurement
  • Packaged Goods Control
  • Parts counting
  • Peak hold
  • Percent Weighing
  • Pipettes Calibration
  • Plus/Minus Control
  • Replaceable unit
  • Samples drying
  • Statistical Quality Control
  • Statistics
  • Totalizing
  • Transactions
  • Under-pan weighing
  • Wi-Fi
  • Additional information line
  • Colour Touch Screen
  • Communicationinterfaces
  • Data exchange throughUSB storage devices
  • Electroniclevel indicator
  • Ergonomic Mechanical Design
  • Extra function keys
  • Grill pan
  • Infraredproximity sensors
  • Interfaces
  • Levelling System
  • Modes
  • Portability
  • SMARTLab
  • USB at the Balance Front
  • CE
  • 2 years warranty
AVK-1000 Automatic Vacuum Mass Comparator Open video
Automatic Vacuum Mass Comparator Open video
RMCS - Radwag Mass Comparator System Open video
Automatic Vacuum Mass Comparator AVK-1000 - Mass Standard Transfer System LOAD LOCK Open video
ELLIPSIS – New Balance by RADWAG Open video
ELLIPSIS – Cutting Edge, Innovative, New Open video
ELLIPSIS – Scan or Tap to Log In Open video
Remote VPN Support on ELLIPSIS Balances Open video
ELLIPSIS – Unlimited Connections Open video
RADWAG Mass Comparators Open video